Помогите с настройкой IDC 5614

[dracon]

Модем стал какой-то задумчивый что ли, да и скорость закачки сильно упала, может кто, что подскажет?

Статистика соединения:

Time Online.................. 01:24:05
Termination Reason........... LOCAL REQUEST
Tx Rate (Last/Init/Min/Max).. 21600/33600/ 4800/33600 bps
Rx Rate (Last/Init/Min/Max).. 21600/33600/12000/33600 bps
Modulation................... V.34bis
Protocol/Compression......... LAP-M/V.42bis
Line Quality................. 5
Tx/Power Drop/Rx Level....... 9/0/19
SNR Last/Min/Max............. 43/34/43
Highest Rx/Tx State.......... 67/67
EQM Sum...................... 0052
RBS Pattern.................. NA
Rate Drop.................... NA
Digital Loss................. None
Retrains Issued/Granted/Auto. 5/23/9
Renegs Issued/Granted........ 79/99
FForwards/FBacks/Denied...... 34/48/0
Forced FB/FB after FF/MaxREJ. 4/9/8
Last dialed number........... PXXXXX
Flex fail 94818303

Symbol Rate.................. 2400
Carrier Frequency Hz, Rx/Tx.. 1600/1600
EQM Value (Last/Min/Max)..... 5/0/127
EQM Hits..................... 0
EQM Last 10 Readings......... 5 5 6 5 5 5 5 5 5 6
Last Retrain/Reneg Status.... Remote Retrain
Last Retrain/Reneg Reason.... Remote Retrain
Last Retrain/Reneg Time...... 2 minutes ago
Handshake Time/Retries....... 29 seconds/1
Non-linear Encoding, Rx/Tx... ON/ON
Precoding, Rx/Tx............. OFF/OFF
Shaping, Rx/Tx............... ON/ON
Trellis Encoding, Tx......... 16 state
Pre-Emphasis Index, Tx....... 2
Band Edges Lower/Upper, Hz... 150/3825
Last Rx/Tx State............. 67/67
Energy at 3750Hz/Average .... 767/277
V.8 Negotiation Started...... Yes
V.8bis Success............... No
V.8bis CRe,CRd,CL,MS,ACK,NAK. Yes/No/No/No/No/No
Remote Manufacturer.......... Rockwell (Conexant)
Remote Licensee Code......... Rockwell (Conexant)
Remote Protocol Support...... K56flex V.90
Remote K56flex Version....... 03
Remote K56flex Capabilities.. Prototype mode is not supported
Remote Type.................. Client (Analog)
Remote supports Power Drop... Yes
Remote is CME Modem.......... No
Remote supports V.34bis...... Yes
Remote Max SR Difference..... 0 Symbol Rate Steps
Remote Frequency Source...... Internal
Error Correction Status Byte. ADP:R ODP:T
Error Correction Status Byte. SYNC UA:R SAMBE:T XID:T XID:R
Frames REJected, Last/Total.. 1/81
Frames Errors, Rx/Tx......... 337/150 (0,5%/1,0%)
Frames Count, Rx/Tx.......... 63701/15060
Error Control Frame Size..... V.42 LAPM (128)
Error Control Timeouts....... 97
Error Control Link NAKs...... 150
Compression Dictionary Size.. V.42bis (2048)
Characters Received.......... 7625043
Characters Sent.............. 378899
Average CPS, Rx/Tx........... 1511/75
Characters Lost, Rx/Tx....... 0/0
Estimated Noise Level, -dBm.. 62

[Technical Support]

Много перетренировок, инициированных удалённым модемом. Попробуйте ограничить скорость передачи Вашего модема, добавив такие команды в строку инициализации (в свойствах модема):

S210.7=1 +MS=11,,,,,,14400
_________________
Inpro
Technical Support

[dracon]

статистика после новой строки инициплизации, улучшений вроде нет
Time Online.................. 00:12:48
Termination Reason........... LOCAL REQUEST
Tx Rate (Last/Init/Min/Max).. 7200/ 7200/ 4800/14400 bps
Rx Rate (Last/Init/Min/Max).. 28800/21600/21600/33600 bps
Modulation................... V.34bis
Protocol/Compression......... LAP-M/V.42bis
Line Quality................. 15
Tx/Power Drop/Rx Level....... 15/0/22
SNR Last/Min/Max............. 37/31/43
Highest Rx/Tx State.......... 85/87
EQM Sum...................... 0004
RBS Pattern.................. NA
Rate Drop.................... NA
Digital Loss................. None
Retrains Issued/Granted/Auto. 2/3/1
Renegs Issued/Granted........ 4/56
FForwards/FBacks/Denied...... 1/3/0
Forced FB/FB after FF/MaxREJ. 1/1/7
Last dialed number........... PXXXXX
Flex fail

Symbol Rate.................. 3200
Carrier Frequency Hz, Rx/Tx.. 1829/1829
EQM Value (Last/Min/Max)..... 15/6/127
EQM Hits..................... 0
EQM Last 10 Readings......... 15 19 15 20 20 17 18 26 20 12
Last Retrain/Reneg Status.... Remote Rate Renegotiation
Last Retrain/Reneg Reason.... Remote Rate Renegotiation
Last Retrain/Reneg Time...... 0 minutes ago
Handshake Time/Retries....... 20 seconds/0
Non-linear Encoding, Rx/Tx... ON/ON
Precoding, Rx/Tx............. ON/ON
Shaping, Rx/Tx............... ON/ON
Trellis Encoding, Tx......... 16 state
Pre-Emphasis Index, Tx....... 3
Band Edges Lower/Upper, Hz... 150/3825
Last Rx/Tx State............. 67/87
Energy at 3750Hz/Average .... 737/267
V.8 Negotiation Started...... Yes
V.8bis Success............... Yes
V.8bis CRe,CRd,CL,MS,ACK,NAK. Yes/No/Yes/No/Yes/No
Remote supports Symbol Rates. 2743 2800 3429 3000(L) 3000(H)
Remote supports Symbol Rates. 3200(L) 3200(H) 3429(Tx)
Remote supports Power Drop... Yes
Remote is CME Modem.......... No
Remote supports V.34bis...... Yes
Remote Max SR Difference..... 0 Symbol Rate Steps
Remote Frequency Source...... Internal
Error Correction Status Byte. ADP:R ODP:T
Error Correction Status Byte. SYNC UA:R SAMBE:T XID:T XID:R
Frames REJected, Last/Total.. 1/64
Frames Errors, Rx/Tx......... 64/18 (0,8%/1,0%)
Frames Count, Rx/Tx.......... 7660/1874
Error Control Frame Size..... V.42 LAPM (128)
Error Control Timeouts....... 63
Error Control Link NAKs...... 18
Compression Dictionary Size.. V.42bis (2048)
Characters Received.......... 846343
Characters Sent.............. 37373
Average CPS, Rx/Tx........... 1102/48
Characters Lost, Rx/Tx....... 0/0
Estimated Noise Level, -dBm.. 59

[Technical Support]

К сожалению, влиять на удалённый модем можно только двумя способами: ограничивая скорость передачи своего модема, и меняя уровень выходной мощности передатчика. Больше никаких рычагов влияния нет. Поэтому, если не удаётся добиться приемлимых результатов, стоит попробовать поискать другого провайдера.
_________________
Inpro
Technical Support