Помогите настроить для калбэка IDC 5614BXL/VR Plus

[Technical Support]

Попробуйте прописать такую строку инициализации:

S91=15 S210.7=1 +MS=11
_________________
Inpro
Technical Support

[kluyg]

прописал, вроде стало лучьше, вот лог:

Inpro IDC Modems Diagnostics, Version 1.0.1.30
05.07.2003 8:03:27 - Outbound Call by RemoteAccess
--------------------------------------------------------
Modem type: IDC-5614BXL/VR+ (Plus) Firmware revision: V2.23

Time Online.................. 03:36:58
Termination Reason........... LOCAL REQUEST
Tx Rate (Last/Init/Min/Max).. 26400/28800/26400/28800 bps
Rx Rate (Last/Init/Min/Max).. 33600/33600/ 9600/33600 bps
Modulation................... V.34bis
Protocol/Compression......... LAP-M/V.42bis
Line Quality................. 43
Tx/Power Drop/Rx Level....... 15/0/27
SNR Last/Min/Max............. 41/15/41
Highest Rx/Tx State.......... 67/87
EQM Sum...................... 0030
RBS Pattern.................. NA
Rate Drop.................... NA
Digital Loss................. None
Retrains Issued/Granted/Auto. 0/11/4
Renegs Issued/Granted........ 51/1
FForwards/FBacks/Denied...... 29/22/0
Forced FB/FB after FF/MaxREJ. 1/1/7
Last dialed number........... P600000
Flex fail


Symbol Rate.................. 3429
Carrier Frequency Hz, Rx/Tx.. 1959/1959
EQM Value (Last/Min/Max)..... 43/0/127
EQM Hits..................... 0
EQM Last 10 Readings......... 43 44 44 42 41 41 47 43 43 45
Last Retrain/Reneg Status.... Remote Retrain
Last Retrain/Reneg Reason.... Remote Retrain
Last Retrain/Reneg Time...... 3 minutes ago
Handshake Time/Retries....... 18 seconds/0
Non-linear Encoding, Rx/Tx... ON/ON
Precoding, Rx/Tx............. ON/ON
Shaping, Rx/Tx............... ON/ON
Trellis Encoding, Tx......... 16 state
Pre-Emphasis Index, Tx....... 2
Band Edges Lower/Upper, Hz... 150/3825
Round trip delay, ms......... 2,6
Last Rx/Tx State............. 67/67
Energy at 3750Hz/Average .... 2076/1615
V.8 Negotiation Started...... Yes
V.8bis Success............... Yes
V.8bis CRe,CRd,CL,MS,ACK,NAK. Yes/No/Yes/No/Yes/No
Remote supports Symbol Rates. 2743 2800 3429 3000(L) 3000(H)
Remote supports Symbol Rates. 3200(L) 3200(H) 3429(Tx)
Remote supports Power Drop... Yes
Remote is CME Modem.......... No
Remote supports V.34bis...... Yes
Remote Max SR Difference..... 0 Symbol Rate Steps
Remote Frequency Source...... Internal
Error Correction Status Byte. ADP:R ODP:T
Error Correction Status Byte. SYNC UA:R SAMBE:T XID:T XID:R
Frames REJected, Last/Total.. 1/17
Frames Errors, Rx/Tx......... 273/101 (0,7%/0,1%)
Frames Count, Rx/Tx.......... 40260/110754
Error Control Frame Size..... V.42 LAPM (128)
Error Control Timeouts....... 82
Error Control Link NAKs...... 101
Compression Dictionary Size.. V.42bis (2048)
Characters Received.......... 3956890
Characters Sent.............. 1720767
Average CPS, Rx/Tx........... 303/132
Characters Lost, Rx/Tx....... 0/0
Estimated Noise Level, -dBm.. 68

[Technical Support]

Учитывая то, что линия весьма нестабильна, придётся признать эти результаты удовлетворительными и на этом поставить точку в настройке модема.
_________________
Inpro
Technical Support

[kluyg]

спасибо за помощь!