А можно и я спрошу?

[Boxa]

С холодильниками я разобрался... Ретрейнов от них нет...
А вот коннект... не очень...
Можно тут что нибудь сделать?


[00:20:26] User request

Time Online.................. 00:06:48
Termination Reason........... LOCAL REQUEST
Tx Rate (Last/Init/Min/Max).. 16800/16800/16800/16800 bps
Rx Rate (Last/Init/Min/Max).. 40000/40000/40000/40000 bps
Modulation................... V.90
Protocol/Compression......... LAP-M/V.42bis
Line Quality................. 34
Tx/Power Drop/Rx Level....... 15/1/16
SNR Last/Min/Max............. 43/43/43
Highest Rx/Tx State.......... 67/67
EQM Sum...................... 0100
RBS Pattern.................. 00
Rate Drop.................... 0
Digital Loss................. 2000
Retrains Issued/Granted/Auto. 0/0/0
Renegs Issued/Granted........ 0/0
FForwards/FBacks/Denied...... 0/0/0
Forced FB/FB after FF/MaxREJ. 0/0/1
Last dialed number........... T399996
V90

Rockwell Diagnostics/W32, version 1.3.0.0, compiled at Jun 13 2002 22:35:06
(c) 2000 Stanislav V. Mekhanoshin (rampitec@tu.spb.ru, 2:5030/172.9@fidonet)
----------------------------------------------------------------------------
Connection time : 00:06:48
Handshake Time/Retries : 16 sec/0
TX Rate (Last/Init/Min/Max) : 16800/16800/16800/16800
RX Rate (Last/Init/Min/Max) : 40000/40000/40000/40000
Modulation/Protocol/Compression : V.90/LAPM/V.42bis
TX Symbol rate : 3200
Signal Level (TX/Power Drop), -dB : 15/1
RX Signal Level (Last/Min/Max), -dB : 16/16/16
Band Edge Lower/Upper, Hz : 150/3825
Round trip delay, ms : 2.563
EQM Value (Last/Min/Max/Negative) : 34/28/57/0
EQM Samples Running Sum : 0100
EQM Last 10 Readings : 35 36 37 36 29 33 32 33 35 34
SNR Ratio (Last/Min/Max), dB : 44/44/44
TX Non-linear Encoding : OFF
TX Precoding : OFF
TX/RX Constellation Shaping : OFF/OFF
TX Trellis Encoding : 16 state
TX Pre-emphasis : 1
TX/RX state (Max TX/RX, Last TX/RX) : 67H/67H, 67H/67H
Error Correction Status : SABME:R UA:T,R XID:T,R SYNC
Dual PCM/120 Hz detection : No/Yes
Energy at 3750Hz/Average Energy : 1757/645
RBS Pattern/Alternating RBS Pattern : 00/00
V.90 Digital Pad/A-law/HighPowerSrv : 0dB/No/No
Retrains (Issued/Granted/Fast) : 0/0/0
Renegs (Issued/Granted) : 0/0
Retrans per frame/Frames rejected : 1/1
Total number of REJ sent/received : 1/4
Last Retrain/Reneg reason : None
Last Retrain/Reneg requested : None
Minutes Since Last Retrain/Reneg : 6
Disconnect reason : LOCAL REQUEST
Remote supports symbol rate (1,2,5) : 2743:ON 2800:ON 3429:ON 3429-TX:ON
Remote supports symbol rate (3,4) : 3000-L:ON 3000-H:ON 3200-L:ON 3200-H:ON
Remote power drop support : ON
Remote max symbol rate difference : 0 steps
Remote is a CME modem : No
Remote supports V.34bis : Yes
Remote frequency source : Internal
Remote is ITU/K56Flex neg/High IMD : No/No/No
V.8 bis CRe detected/early : No/No
CRe/CRd/CL/MS/ACK/NAK received : No/No/No/No/No/No
V.8bis success/V.8bis neg started : No/Yes


Unimodem Diagnostics/W32, version 1.1.0.0, compiled at Mar 14 2002 18:00:43
(c) 2000 Stanislav V. Mekhanoshin (rampitec@tu.spb.ru, 2:5030/172.9@fidonet)
----------------------------------------------------------------------------
Diag Command Specification rev.: 1.0
Call Setup Result code : Data Calling signal detected
Multi-media mode : Data Only
DTE-DCE interface mode : Async data
TX/RX signal power level, -dBm : 16/16
Estimated noise level, -dBm : 59
TX/RX Negotiation : V.34/V.90 Issue 1 (asymmetric)
TX/RX Symbol Rate : 3200/8000
TX/RX Carrier frequency, Hz : 1829/0
TX data rate (Last/Init) : 16800/16800
RX data rate (Last/Init) : 40000/40000
Temporary carrier loss count : 0
Carrier Rate Re-neg count : 0
Retrains Requested/Granted : 0/0
Protocol/Compression : V.42 LAPM/V.42bis
Error control frame size, bytes: 128
Error control timeouts in TX : 1
Error control NAKs received : 4
Compression dict. size, bytes : 2048
TX/RX flow control : V.24 ckt 106/133 / V.24 ckt 106/133
TX/RX chars sent : 135016/595614
TX/RX chars lost (data overrun): 0/0
TX/RX I-Frame count : 1834/4310
TX/RX I-Frame error count : 4/1
Termination Cause : cct108 turned Off
_________________
Ну, пока...

[Technical Support]

А что именно не устраивает? По статистике, всё в пределах нормы (и даже лучше).
_________________
Inpro
Technical Support

[Boxa]

[Игорь Тимашков]

> Dual PCM/120 Hz detection : No/Yes

Тебе нужно залить прошивку 2.23
Там доп. фильтр для низкочастотного шума.

[Boxa]

[Technical Support]

[Boxa]

[Technical Support]