подскажите инит-строчку

[Porezov]

Модем IDC 5614 BXL VR+.
Сейчас вот такая инит-строчка:
AT\N4M6S17=72S50=14S91=11S210=173+MS=11
Проблема в том, что при работе с интернет-провайдером модем время от времени срывается в сплошные ренеги/ретрейны.

=== Статистика-1 (к сожалению, только AT%S0 и меньше 6-ти минут).

Time Online.................. 00:05:46
Termination Reason........... NO REMOTE RESPONSE
Tx Rate (Last/Init/Min/Max).. 16800/24000/16800/26400 bps
Rx Rate (Last/Init/Min/Max).. 26400/33600/21600/33600 bps
Modulation................... V.34bis
Protocol/Compression......... LAP-M/V.42bis
Line Quality................. 105
Tx/Power Drop/Rx Level....... 11/0/15
SNR Last/Min/Max............. 29/29/36
Highest Rx/Tx State.......... 67/87
EQM Sum...................... 0052
RBS Pattern.................. NA
Rate Drop.................... NA
Digital Loss................. None
Retrains Issued/Granted/Auto. 1/6/3
Renegs Issued/Granted........ 10/0
FForwards/FBacks/Denied...... 1/10/0
Forced FB/FB after FF/MaxREJ. 1/0/7
Last dialed number........... PP1023440
Flex fail

OK


=== Статистика-2 (тут AT%S0%S1#UD):

Time Online.................. 00:09:38
Termination Reason........... NO REMOTE RESPONSE
Tx Rate (Last/Init/Min/Max).. 9600/16800/ 9600/21600 bps
Rx Rate (Last/Init/Min/Max).. 19200/24000/19200/24000 bps
Modulation................... V.34bis
Protocol/Compression......... LAP-M/V.42bis
Line Quality................. 125
Tx/Power Drop/Rx Level....... 11/0/9
SNR Last/Min/Max............. 43/43/43
Highest Rx/Tx State.......... 67/87
EQM Sum...................... 00E8
RBS Pattern.................. NA
Rate Drop.................... NA
Digital Loss................. None
Retrains Issued/Granted/Auto. 0/0/1
Renegs Issued/Granted........ 3/27
FForwards/FBacks/Denied...... 0/3/0
Forced FB/FB after FF/MaxREJ. 0/0/5
Last dialed number........... P1129378
Flex fail

OK
----------------------------------------------------------------------------
Rockwell Diagnostics/W32, version 1.3.0.0, compiled at Jun 13 2002 22:35:06
(c) 2000 Stanislav V. Mekhanoshin (rampitec@tu.spb.ru, 2:5030/172.9@fidonet)
----------------------------------------------------------------------------
Connection time : 00:09:38
Handshake Time/Retries : 18 sec/0
TX Rate (Last/Init/Min/Max) : 9600/16800/9600/21600
RX Rate (Last/Init/Min/Max) : 19200/24000/19200/24000
Modulation/Protocol/Compression : V.34/LAPM/V.42bis
TX Symbol rate : 3429
TX/RX carrier frequency, Hz : 1959/1959
Signal Level (TX/Power Drop), -dB : 11/0
RX Signal Level (Last/Min/Max), -dB : 9/46/9
Band Edge Lower/Upper, Hz : 150/3825
Round trip delay, ms : 4.333
EQM Value (Last/Min/Max/Negative) : 125/6/127/0
EQM Samples Running Sum : 00E8
EQM Last 10 Readings : 125 124 126 126 127 127 43 40 40 39
SNR Ratio (Last/Min/Max), dB : 44/44/44
TX/RX Non-linear Encoding : ON/ON
TX/RX Precoding : OFF/ON
TX/RX Constellation Shaping : ON/ON
TX Trellis Encoding : 64 state
TX Pre-emphasis : 2
TX/RX state (Max TX/RX, Last TX/RX) : 87H/67H, 20H/22H
Error Correction Status : SABME:T UA:R XID:T,R SYNC
Energy at 3750Hz/Average Energy : 252/379
Retrains (Issued/Granted/Fast) : 0/0/0
Renegs (Issued/Granted) : 3/27
Retrans per frame/Frames rejected : 2/61
Total number of REJ sent/received : 61/12
Last Retrain/Reneg reason : Fall-back due to high EQM
Last Retrain/Reneg requested : Local Rate Renegotiation
Minutes Since Last Retrain/Reneg : 0
Disconnect reason : NO REMOTE RESPONSE
Remote supports symbol rate (1,2,5) : 2743:ON 2800:ON 3429:ON 3429-TX:ON
Remote supports symbol rate (3,4) : 3000-L:ON 3000-H:ON 3200-L:ON 3200-H:ON
Remote power drop support : ON
Remote max symbol rate difference : 0 steps
Remote is a CME modem : No
Remote supports V.34bis : Yes
Remote frequency source : Internal
CRe/CRd/CL/MS/ACK/NAK received : No/No/No/No/No/No
V.8bis success/V.8bis neg started : No/Yes
Workaround used : ABCODE check (machine-gun noise WA)
----------------------------------------------------------------------------
Unimodem Diagnostics/W32, version 1.1.0.1, compiled at Nov 20 2002 22:29:58
(c) 2000 Stanislav V. Mekhanoshin (rampitec@tu.spb.ru, 2:5030/172.9@fidonet)
----------------------------------------------------------------------------
Diag Command Specification rev.: 1.0
Call Setup Result code : Data Answering signal detected
Multi-media mode : Data Only
DTE-DCE interface mode : Async data
TX/RX signal power level, -dBm : 11/9
Estimated noise level, -dBm : 52
TX/RX Negotiation : V.34/V.34
TX/RX Symbol Rate : 3429/3429
TX/RX Carrier frequency, Hz : 1959/1959
TX data rate (Last/Init) : 9600/16800
RX data rate (Last/Init) : 19200/24000
Temporary carrier loss count : 0
Carrier Rate Re-neg count : 30
Retrains Requested/Granted : 0/0
Protocol/Compression : V.42 LAPM/V.42bis
Error control frame size, bytes: 128
Error control timeouts in TX : 8
Error control NAKs received : 12
Compression dict. size, bytes : 2048
TX/RX flow control : V.24 ckt 106/133 / V.24 ckt 106/133
TX/RX chars sent : 105416/842381
TX/RX chars lost (data overrun): 0/0
TX/RX I-Frame count : 2035/7625
TX/RX I-Frame error count : 12/61
Termination Cause : cct108 turned Off


Dmitry

[Technical Support]

По первому случаю сказать трудно, нужна полная статистика. По второму: на удалённой стороне кто-то из US Robotics, он и запрашивал практически все пересогласования:

Renegs Issued/Granted........ 3/27

Попробуйте ограничить скорость передачи Вашего модема командой:

+MS=11,,,,,,9600
_________________
Inpro
Technical Support

[Porezov]

[Technical Support]