| Предыдущая тема :: Следующая тема |
| Автор |
Сообщение |
Frodo Sumkin
Associated member
Зарегистрирован: 17.09.2007
Сообщения: 11
|
 Добавлено: Пн Сен 17, 2007 8:58 am Заголовок сообщения: |
 |
|
А можно ли что поделать с такой линией?
| Код: | Inpro IDC Modems Diagnostics, Version: 1.1.4.39
14.09.2007 9:06:48 - Direct Log Write Entry
--------------------------------------------------------
Modem Type: IDC-5614BXL/VR+ (Plus) Firmware Revision: V2.26
System Modem Init String: AT&FS38=0S95=41S115=0E0<cr>
User Modem Init String: <none>
Time Online.................. 00:52:01
Termination Reason........... NO REMOTE RESPONSE
Tx Rate (Last/Init/Min/Max).. 21600/28800/19200/31200 bps
Rx Rate (Last/Init/Min/Max).. 21600/33333/21600/34667 bps
Modulation................... V.34bis
Protocol/Compression......... LAP-M/V.42bis
Line Quality................. 126
Tx/Power Drop/Rx Level....... 15/3/6
SNR Last/Min/Max............. 43/43/43
Highest Rx/Tx State.......... 67/84
EQM Sum...................... 00EE
RBS Pattern.................. 00
Rate Drop.................... 0
Digital Loss................. None
Retrains Issued/Granted/Auto. 1/6/6
Renegs Issued/Granted........ 19/4
FForwards/FBacks/FEQM/Denied. 7/12/10/0
Forced FB/FB after FF/MaxREJ. 1/2/7
Last dialed number........... P55-777
Flex fail 9481834347EB
Negotiation Result (Rx/Tx)... V.34/V.34
Symbol Rate.................. 2400
Carrier Frequency Hz, Rx/Tx.. 1600/1600
EQM Value (Last/Min/Max)..... 126/2/127
EQM Hits..................... 0
EQM Last 10 Readings......... 127 127 126 126 127 127 15 14 14 17
Last Retrain/Reneg Status.... Local Rate Renegotiation
Last Retrain/Reneg Reason.... Local Fallback due to High EQM
Reason for V.34 Fallback..... Data Pump decision to Fallback in Phase 2
Last Retrain/Reneg Time...... 0 minutes ago
Handshake Time/Retries....... 41 seconds/0
Non-linear Encoding, Rx/Tx... ON/ON
Precoding, Rx/Tx............. OFF/OFF
Shaping, Rx/Tx............... ON/ON
Trellis Encoding, Tx......... 16 state
Pre-Emphasis Index, Tx....... 0
Band Edges Lower/Upper, Hz... 150/3825
Round trip delay, ms......... 5,6
Last Rx/Tx State............. 67/84
Energy at 3750Hz/Average .... 4512/3020
Auto Gain Amplitude, db...... 10
Rx Level (Last/Min/Max), -dB. 5,0/17,9/5,0
V.8 Negotiation Started...... Yes
V.8bis Success............... Yes
V.8bis CRe,CRd,CL,MS,ACK,NAK. Yes/No/Yes/No/Yes/No
Remote Manufacturer.......... Rockwell (Conexant)
Remote Licensee Code......... Rockwell (Conexant)
Remote Protocol Support...... K56flex V.90
Remote K56flex Version....... 03
Remote K56flex Capabilities.. Prototype mode is not supported
Remote Type.................. Server (Digital)
Remote supports Symbol Rates. 2743 2800 3429 3000(L) 3000(H)
Remote supports Symbol Rates. 3200(L) 3200(H) 3429(Tx)
Remote supports Power Drop... Yes
Remote is CME Modem.......... No
Remote supports V.34bis...... Yes
Remote Max SR Difference..... 0 Symbol Rate Steps
Remote Frequency Source...... Unknown
Error Correction Status Byte. SYNC UA:R SAMBE:T XID:T XID:R
Frames REJected, Last/Total.. 0/7
Frames Errors, Rx/Tx......... 263/28 (0,7%/0,2%)
Frames Count, Rx/Tx.......... 37929/11722
Error Control Frame Size..... V.42 LAPM (128)
Error Control Timeouts....... 44
Error Control Link NAKs...... 28
Compression Dictionary Size.. V.42bis (2048)
Characters Received.......... 4 643 513
Characters Sent.............. 778 440
Average CPS, Rx/Tx........... 1487/249
Characters Lost, Rx/Tx....... 0/0
Estimated Noise Level, -dBm.. 49 |
|
|
| Вернуться к началу |
|
 |
Frodo Sumkin
Associated member
Зарегистрирован: 17.09.2007
Сообщения: 11
|
| Добавлено: Пн Сен 17, 2007 8:59 am Заголовок сообщения: |
|
|
А можно ли что поделать с такой линией?
| Код: | Inpro IDC Modems Diagnostics, Version: 1.1.4.39
14.09.2007 9:06:48 - Direct Log Write Entry
--------------------------------------------------------
Modem Type: IDC-5614BXL/VR+ (Plus) Firmware Revision: V2.26
System Modem Init String: AT&FS38=0S95=41S115=0E0<cr>
User Modem Init String: <none>
Time Online.................. 00:52:01
Termination Reason........... NO REMOTE RESPONSE
Tx Rate (Last/Init/Min/Max).. 21600/28800/19200/31200 bps
Rx Rate (Last/Init/Min/Max).. 21600/33333/21600/34667 bps
Modulation................... V.34bis
Protocol/Compression......... LAP-M/V.42bis
Line Quality................. 126
Tx/Power Drop/Rx Level....... 15/3/6
SNR Last/Min/Max............. 43/43/43
Highest Rx/Tx State.......... 67/84
EQM Sum...................... 00EE
RBS Pattern.................. 00
Rate Drop.................... 0
Digital Loss................. None
Retrains Issued/Granted/Auto. 1/6/6
Renegs Issued/Granted........ 19/4
FForwards/FBacks/FEQM/Denied. 7/12/10/0
Forced FB/FB after FF/MaxREJ. 1/2/7
Last dialed number........... P55-777
Flex fail 9481834347EB
Negotiation Result (Rx/Tx)... V.34/V.34
Symbol Rate.................. 2400
Carrier Frequency Hz, Rx/Tx.. 1600/1600
EQM Value (Last/Min/Max)..... 126/2/127
EQM Hits..................... 0
EQM Last 10 Readings......... 127 127 126 126 127 127 15 14 14 17
Last Retrain/Reneg Status.... Local Rate Renegotiation
Last Retrain/Reneg Reason.... Local Fallback due to High EQM
Reason for V.34 Fallback..... Data Pump decision to Fallback in Phase 2
Last Retrain/Reneg Time...... 0 minutes ago
Handshake Time/Retries....... 41 seconds/0
Non-linear Encoding, Rx/Tx... ON/ON
Precoding, Rx/Tx............. OFF/OFF
Shaping, Rx/Tx............... ON/ON
Trellis Encoding, Tx......... 16 state
Pre-Emphasis Index, Tx....... 0
Band Edges Lower/Upper, Hz... 150/3825
Round trip delay, ms......... 5,6
Last Rx/Tx State............. 67/84
Energy at 3750Hz/Average .... 4512/3020
Auto Gain Amplitude, db...... 10
Rx Level (Last/Min/Max), -dB. 5,0/17,9/5,0
V.8 Negotiation Started...... Yes
V.8bis Success............... Yes
V.8bis CRe,CRd,CL,MS,ACK,NAK. Yes/No/Yes/No/Yes/No
Remote Manufacturer.......... Rockwell (Conexant)
Remote Licensee Code......... Rockwell (Conexant)
Remote Protocol Support...... K56flex V.90
Remote K56flex Version....... 03
Remote K56flex Capabilities.. Prototype mode is not supported
Remote Type.................. Server (Digital)
Remote supports Symbol Rates. 2743 2800 3429 3000(L) 3000(H)
Remote supports Symbol Rates. 3200(L) 3200(H) 3429(Tx)
Remote supports Power Drop... Yes
Remote is CME Modem.......... No
Remote supports V.34bis...... Yes
Remote Max SR Difference..... 0 Symbol Rate Steps
Remote Frequency Source...... Unknown
Error Correction Status Byte. SYNC UA:R SAMBE:T XID:T XID:R
Frames REJected, Last/Total.. 0/7
Frames Errors, Rx/Tx......... 263/28 (0,7%/0,2%)
Frames Count, Rx/Tx.......... 37929/11722
Error Control Frame Size..... V.42 LAPM (128)
Error Control Timeouts....... 44
Error Control Link NAKs...... 28
Compression Dictionary Size.. V.42bis (2048)
Characters Received.......... 4 643 513
Characters Sent.............. 778 440
Average CPS, Rx/Tx........... 1487/249
Characters Lost, Rx/Tx....... 0/0
Estimated Noise Level, -dBm.. 49 |
|
|
| Вернуться к началу |
|
|
Technical Support
Expert
Зарегистрирован: 31.10.2002
Сообщения: 6330
|
| Добавлено: Пн Сен 17, 2007 7:46 pm Заголовок сообщения: |
|
|
Попробуйте такую строку инициализации:
S91=15 S210.7=1 +MS=11
и покажите, что получается в статистике.
_________________
Inpro
Technical Support |
|
| Вернуться к началу |
|
|
|
|
Вы не можете начинать темы
Вы не можете отвечать на сообщения
Вы не можете редактировать свои сообщения
Вы не можете удалять свои сообщения
Вы не можете голосовать в опросах
|
Powered by phpBB © 2001, 2005 phpBB Group
|
FAQ
Поиск
Пользователи
Группы
Регистрация
Профиль
Войти и проверить личные сообщения
Вход
