Поможите настроить, пожалуста

[frost_ii]

Замучили исходящие ретрейны

Вот статистика.

Rockwell Diagnostics/W32, version 1.3.0.0, compiled at Jun 13 2002 22:35:24
(c) 2000 Stanislav V. Mekhanoshin (rampitec@tu.spb.ru, 2:5030/172.9@fidonet)
----------------------------------------------------------------------------
Connection time : 00:05:54
Handshake Time/Retries : 25 sec/0
TX Rate (Last/Init/Min/Max) : 24000/24000/21600/24000
RX Rate (Last/Init/Min/Max) : 33333/33333/29333/36000
Modulation/Protocol/Compression : V.90/LAPM/V.42bis
TX Symbol rate : 3200
Signal Level (TX/Power Drop), -dB : 15/0
RX Signal Level (Last/Min/Max), -dB : 20/20/20
Band Edge Lower/Upper, Hz : 150/3825
Round trip delay, ms : 3.813
EQM Value (Last/Min/Max/Negative) : 126/7/127/0
EQM Samples Running Sum : 010B
EQM Last 10 Readings : 126 127 127 127 127 127 12 14 9 11
SNR Ratio (Last/Min/Max), dB : 36/34/37
TX Non-linear Encoding : OFF
TX Precoding : OFF
TX/RX Constellation Shaping : OFF/OFF
TX Trellis Encoding : 16 state
TX Pre-emphasis : 2
TX/RX state (Max TX/RX, Last TX/RX) : 67H/67H, 67H/65H
Error Correction Status : SABME:T UA:R XID:T,R SYNC
Dual PCM/120 Hz detection : No/Yes
Energy at 3750Hz/Average Energy : 362/65
RBS Pattern/Alternating RBS Pattern : 00/00
V.90 Digital Pad/A-law/HighPowerSrv : 0dB/Yes/No
Retrains (Issued/Granted/Fast) : 7/2/3
Renegs (Issued/Granted) : 0/0
Retrans per frame/Frames rejected : 0/12
Total number of REJ sent/received : 12/0
Last Retrain/Reneg reason : Fall-back due to high EQM
Last Retrain/Reneg requested : Local Retrain
Minutes Since Last Retrain/Reneg : 0
Disconnect reason : LOCAL REQUEST
Remote Manufacturer/Licensee Code : Conexant/Conexant
Remote Manufacturer's Product Caps : K56Flex, V.90
Remote V.8bis caps (type) : Digital (Server)
Remote V.8bis caps (K56Flex mode) : K56Flex prototype mode not supported
Remote V.8bis caps (K56Flex version): 1.1
Remote K56Flex RAM version supported: 70
Remote Coding used/forced by server : A-law/Yes
Remote controller version number : 0
Remote supports symbol rate (1,2,5) : 2743:ON 2800:ON 3429:ON 3429-TX:ON
Remote supports symbol rate (3,4) : 3000-L:ON 3000-H:ON 3200-L:ON 3200-H:ON
Remote power drop support : ON
Remote max symbol rate difference : 0 steps
Remote is a CME modem : No
Remote supports V.34bis : Yes
Remote frequency source : External
Remote is ITU/K56Flex neg/High IMD : Yes/Yes/No
V.8 bis CRe detected/early : Yes/No
CRe/CRd/CL/MS/ACK/NAK received : Yes/No/Yes/No/Yes/No
V.8bis success/V.8bis neg started : Yes/Yes

[Technical Support]

В такой ситуации нужно отказываться от V.90 и работать на V.34. Соответствующую команду:

+MS=11

нужно записать в строку инициализации в свойствах модема.
_________________
Inpro
Technical Support

[frost_ii]

Писал, получаю на связи v34 без bis 8-|, 28800 максимум. Статистику приложу чуть позже. Кстати, ретрейны остаются.

[Technical Support]