Помогите с настройкой IDC-2814BXL/VR+

[soil]

Часто дисконнектится, может уменьшить скорость?
Вот лог.
------------------


Inpro IDC Modems Diagnostics, Version: 1.1.4.39
08.02.2006 21:13:29 - Direct Log Write Entry
--------------------------------------------------------
Modem Type: IDC-2814BXL/VR+ (Plus) Firmware Revision: V2.20
System Modem Init String: AT&FS95=41E0<cr>
User Modem Init String:

Time Online.................. 00:05:29
Termination Reason........... NO REMOTE RESPONSE
Tx Rate (Last/Init/Min/Max).. 24000/24000/19200/26400 bps
Rx Rate (Last/Init/Min/Max).. 26400/28800/24000/31200 bps
Modulation................... V.34bis
Protocol/Compression......... LAP-M/V.42bis
Line Quality................. 15
Tx/Power Drop/Rx Level....... 9/7/NA
SNR Last/Min/Max............. 34/34/39
Highest Rx/Tx State.......... 60/87
EQM Sum...................... 0079
Retrains Issued/Granted/Auto. 0/1/0
Renegs Issued/Granted........ 4/8
FForwards/FBacks/Denied...... 2/2/0


Negotiation Result (Rx/Tx)... V.34/V.34
Symbol Rate.................. 3429
Carrier Frequency Hz, Rx/Tx.. 1959/1959
EQM Value (Last/Min/Max)..... 15/9/127
EQM Hits..................... 0
EQM Last 10 Readings......... 14 21 14 20 15 16 13 15 13 12
Last Retrain/Reneg Status.... Remote Retrain
Last Retrain/Reneg Reason.... Remote Retrain
Last Retrain/Reneg Time...... 2 minutes ago
Handshake Time/Retries....... 25 seconds/1
Non-linear Encoding, Rx/Tx... ON/ON
Precoding, Rx/Tx............. ON/ON
Shaping, Rx/Tx............... ON/ON
Trellis Encoding, Tx......... 16 state
Pre-Emphasis Index, Tx....... 10
Band Edges Lower/Upper, Hz... 150/3825
Round trip delay, ms......... 0,5
Last Rx/Tx State............. 2C/2C
Energy at 3750Hz/Average .... 147/535
Rx Level (Last/Min/Max), -dB. NA/22,0/21,6d
Detection of 120 Hz Tones.... No
Detection of Dual PCM........ Yes
V.8 Negotiation Started...... Yes
V.8bis Success............... No
V.8bis CRe,CRd,CL,MS,ACK,NAK. No/No/No/No/No/No
Remote supports Symbol Rates. 2743 2800 3429 3000(L) 3000(H)
Remote supports Symbol Rates. 3200(L) 3200(H) 3429(Tx)
Remote supports Power Drop... Yes
Remote is CME Modem.......... No
Remote supports V.34bis...... Yes
Remote Max SR Difference..... 0 Symbol Rate Steps
Remote Frequency Source...... Internal
Error Correction Status Byte. ADP:R ODP:T
Error Correction Status Byte. SYNC UA:R SAMBE:T XID:T XID:R
Frames REJected, Last/Total.. 0/23
Frames Errors, Rx/Tx......... 23/5 (0,3%/0,6%)
Frames Count, Rx/Tx.......... 7968/871
Error Control Frame Size..... V.42 LAPM (128)
Error Control Timeouts....... 8
Error Control Link NAKs...... 5
Compression Dictionary Size.. V.42bis (1792)
Characters Received.......... 254 412
Characters Sent.............. 55 130
Average CPS, Rx/Tx........... 773/167
Characters Lost, Rx/Tx....... 0/0
Estimated Noise Level, -dBm.. 86

[Technical Support]

Для начала обновите микропрограмму (текущая версия 2.26) и пропишите в строке инициализации такие команды:

S91=12 S210.7=1

После этого покажите, что получается в статистике.
_________________
Inpro
Technical Support