настройка 5614 на 2.26

[MIXA82]

Подскажите пожалуйста, как повысить скорость модема и какую строку инициализации в данном случае необходимо прописать?

Статистика:

Inpro IDC 2814/5614 BXL/VR Diagnostics, Version 1.0.1.30
17.07.2005 3:04:10 - Manual Diagnostics Request
--------------------------------------------------------
Modem type: IDC-5614BXL/VR+ (Plus) Firmware revision: V2.26

Time Online.................. 00:53:12
Termination Reason........... LOCAL REQUEST
Tx Rate (Last/Init/Min/Max).. 31200/28800/28800/31200 bps
Rx Rate (Last/Init/Min/Max).. 45333/42667/42667/45333 bps
Modulation................... V.90
Protocol/Compression......... LAP-M/V.42bis
Line Quality................. 26
Tx/Power Drop/Rx Level....... 15/2/18
SNR Last/Min/Max............. 43/43/43
Highest Rx/Tx State.......... 67/87
EQM Sum...................... 00EB
RBS Pattern.................. 00
Rate Drop.................... 0
Digital Loss................. 2000
Retrains Issued/Granted/Auto. 0/0/0
Renegs Issued/Granted........ 2/1
FForwards/FBacks/FEQM/Denied. 1/1/0/0
Forced FB/FB after FF/MaxREJ. 0/0/3
Last dialed number........... T8W600100
V90

Symbol Rate.................. 3200
Carrier Frequency Hz, Tx..... 1920
EQM Value (Last/Min/Max)..... 26/17/118
EQM Hits..................... 0
EQM Last 10 Readings......... 26 26 28 26 26 26 23 26 27 25
Last Retrain/Reneg Status.... Local Fast Retrain
Last Retrain/Reneg Reason.... Local Fallback due to High EQM
Last Retrain/Reneg Time...... 2 minutes ago
Handshake Time/Retries....... 21 seconds/0
Non-linear Encoding, Rx/Tx... OFF/OFF
Precoding, Rx/Tx............. OFF/OFF
Shaping, Rx/Tx............... OFF/OFF
Trellis Encoding, Tx......... 16 state
Pre-Emphasis Index, Tx....... 6
Band Edges Lower/Upper, Hz... 150/3825
Round trip delay, ms......... 2,6
Last Rx/Tx State............. 65/87
Energy at 3750Hz/Average .... 1365/1125
Auto Gain Amplitude, db...... 10
Detection of 120 Hz Tones.... No
Detection of Dual PCM........ No
V.90 RBS Pattern............. 00
V.90 Alternating RBS Pattern. 00
V.90 Digital Pad Value, db... 0,0
V.90 Optimal Speed........... No Limit (Reg.S120=0)
V.8 Negotiation Started...... Yes
V.8bis Success............... No
V.8bis CRe,CRd,CL,MS,ACK,NAK. No/No/No/No/No/No
Remote supports Symbol Rates. 2743 2800 3429 3000(L) 3000(H)
Remote supports Symbol Rates. 3200(L) 3200(H) 3429(Tx)
Remote supports Power Drop... Yes
Remote is CME Modem.......... No
Remote supports V.34bis...... Yes
Remote Max SR Difference..... 0 Symbol Rate Steps
Remote Frequency Source...... External
Error Correction Status Byte. SYNC UA:R SAMBE:T XID:T XID:R
Frames REJected, Last/Total.. 1/103
Frames Errors, Rx/Tx......... 103/15 (0,1%/0,1%)
Frames Count, Rx/Tx.......... 86151/19936
Error Control Frame Size..... V.42 LAPM (128)
Error Control Timeouts....... 6
Error Control Link NAKs...... 15
Compression Dictionary Size.. V.42bis (2048)
Characters Received.......... 11661390
Characters Sent.............. 1086340
Average CPS, Rx/Tx........... 3653/340
Characters Lost, Rx/Tx....... 0/0
Estimated Noise Level, -dBm.. 61

Заранее премного благодарен. Давний пользователь IDC.

[Technical Support]

Попробуйте такую строку инициализации:

S91=18 S210.7=1 S55.4=1 S17=56
_________________
Inpro
Technical Support