Помогите с модемом IDC-5614 BXL/VR, пожалусто.

[Sibman]

Здравствуйте, дело в том, что у меня аналоговая АТС и скорость коннекта редко превышает 33600, максимум это 45200 (1 из 1000 раз), моя строка инициализации: S91=15 S210.7=1 S55.4=1 S17=64 S210.4=1 +MS=,,,,,,24000, помогите подобрать нужную.

Rockwell Diagnostics/W32, version 1.3.0.0, compiled at Jun 13 2002 22:35:24
(c) 2000 Stanislav V. Mekhanoshin (rampitec@tu.spb.ru, 2:5030/172.9@fidonet)
----------------------------------------------------------------------------
Connection time : 00:13:39
Handshake Time/Retries : 27 sec/0
TX Rate (Last/Init/Min/Max) : 24000/24000/24000/24000
RX Rate (Last/Init/Min/Max) : 40000/44000/36000/44000
Modulation/Protocol/Compression : V.90/LAPM/V.42bis
TX Symbol rate : 3200
Signal Level (TX/Power Drop), -dB : 15/0
RX Signal Level (Last/Min/Max), -dB : 11/11/11
Band Edge Lower/Upper, Hz : 150/3825
Round trip delay, ms : 3.500
EQM Value (Last/Min/Max/Negative) : 27/12/127/0
EQM Samples Running Sum : 00D8
EQM Last 10 Readings : 24 25 25 27 27 26 24 24 23 26
SNR Ratio (Last/Min/Max), dB : 39/39/39
TX Non-linear Encoding : ON
TX Precoding : ON
TX/RX Constellation Shaping : ON/OFF
TX Trellis Encoding : 16 state
TX Pre-emphasis : 1
TX/RX state (Max TX/RX, Last TX/RX) : 87H/67H, 87H/67H
Error Correction Status : SABME:T UA:R XID:T,R SYNC
Dual PCM/120 Hz detection : No/Yes
Energy at 3750Hz/Average Energy : 1469/1447
RBS Pattern/Alternating RBS Pattern : 00/00
V.90 Digital Pad/A-law/HighPowerSrv : 0dB/Yes/No
Retrains (Issued/Granted/Fast) : 3/0/2
Renegs (Issued/Granted) : 0/0
Retrans per frame/Frames rejected : 1/35
Total number of REJ sent/received : 35/4
Last Retrain/Reneg reason : Fall-forward due to low EQM
Last Retrain/Reneg requested : Local Fast Retrain
Minutes Since Last Retrain/Reneg : 12
Disconnect reason : LOCAL REQUEST
Remote Manufacturer/Licensee Code : Conexant/Conexant
Remote Manufacturer's Product Caps : K56Flex, V.90
Remote V.8bis caps (type) : Digital (Server)
Remote V.8bis caps (K56Flex mode) : K56Flex prototype mode not supported
Remote V.8bis caps (K56Flex version): 1.0, 1.1
Remote K56Flex RAM version supported: 71
Remote Coding used/forced by server : A-law/Yes
Remote controller version number : 11
Remote supports symbol rate (1,2,5) : 2743:ON 2800:ON 3429:ON 3429-TX:ON
Remote supports symbol rate (3,4) : 3000-L:ON 3000-H:ON 3200-L:ON 3200-H:ON
Remote power drop support : ON
Remote max symbol rate difference : 0 steps
Remote is a CME modem : No
Remote supports V.34bis : Yes
Remote frequency source : ITU-reserved
Remote is ITU/K56Flex neg/High IMD : Yes/Yes/No
V.8 bis CRe detected/early : Yes/No
CRe/CRd/CL/MS/ACK/NAK received : Yes/No/Yes/No/Yes/No
V.8bis success/V.8bis neg started : Yes/Yes

Заранее спасибо.

P.S. Я в этом деле ламер

[Technical Support]

Хотелось бы увидеть полную статистику (а не только at%s1). Лучше всего Вам накопить такую статистику с помощью программы IDC Diagnostics, установив в ней Options / Monitor TAPI activity, заархивировать журнал и выслать его нам на e-mail: support@inpro.us.com.
_________________
Inpro
Technical Support

[Sibman]

Хорошо, так и сделаю.