настройка модема

[andreww]

подскажите строку инициализации.



Inpro IDC 2814/5614 BXL/VR Diagnostics, Version 1.0.1.29
22.07.04 23:00:32 - Manual Diagnostics Request
--------------------------------------------------------
Modem type: IDC-5614BXL/VR+ (Plus) Firmware revision: V2.24

Time Online.................. 00:16:08
Termination Reason........... LOCAL REQUEST
Tx Rate (Last/Init/Min/Max).. 21600/19200/19200/24000 bps
Rx Rate (Last/Init/Min/Max).. 28800/28800/21600/28800 bps
Modulation................... V.34bis
Protocol/Compression......... LAP-M/V.42bis
Line Quality................. 36
Tx/Power Drop/Rx Level....... 15/0/36
SNR Last/Min/Max............. 29/29/32
Highest Rx/Tx State.......... 85/87
EQM Sum...................... 0040
RBS Pattern.................. NA
Rate Drop.................... NA
Digital Loss................. None
Retrains Issued/Granted/Auto. 0/3/0
Renegs Issued/Granted........ 3/4
FForwards/FBacks/Denied...... 0/3/0
Forced FB/FB after FF/MaxREJ. 3/0/10

Symbol Rate.................. 3200
Carrier Frequency Hz, Rx/Tx.. 1829/1829
EQM Value (Last/Min/Max)..... 36/26/86
EQM Hits..................... 0
EQM Last 10 Readings......... 32 31 37 31 34 35 38 32 36 37
Last Retrain/Reneg Status.... Remote Rate Renegotiation
Last Retrain/Reneg Reason.... Remote Rate Renegotiation
Reason for V.34 Fallback..... Data Pump decision to Fallback in Phase 2
Last Retrain/Reneg Time...... 2 minutes ago
Handshake Time/Retries....... 22 seconds/0
Non-linear Encoding, Rx/Tx... ON/OFF
Precoding, Rx/Tx............. ON/OFF
Shaping, Rx/Tx............... ON/OFF
Trellis Encoding, Tx......... 16 state
Pre-Emphasis Index, Tx....... 3
Band Edges Lower/Upper, Hz... 150/3825
Round trip delay, ms......... 6,3
Last Rx/Tx State............. 67/87
Energy at 3750Hz/Average .... 8/85
Detection of 120 Hz Tones.... Yes
Detection of Dual PCM........ Yes
V.8 Negotiation Started...... Yes
V.8bis Success............... Yes
V.8bis CRe,CRd,CL,MS,ACK,NAK. Yes/No/Yes/No/Yes/No
Remote Manufacturer.......... Rockwell (Conexant)
Remote Licensee Code......... Rockwell (Conexant)
Remote Protocol Support...... K56flex V.90
Remote K56flex Version....... 02
Remote K56flex Capabilities.. Prototype mode is not supported
Remote Type.................. Server (Digital)
Remote supports Symbol Rates. 2743 2800 3429 3000(L) 3000(H)
Remote supports Symbol Rates. 3200(L) 3200(H) 3429(Tx)
Remote supports Power Drop... Yes
Remote is CME Modem.......... No
Remote supports V.34bis...... Yes
Remote Max SR Difference..... 0 Symbol Rate Steps
Remote Frequency Source...... Internal
Error Correction Status Byte. SYNC UA:R SAMBE:T XID:T XID:R
Frames REJected, Last/Total.. 1/159
Frames Errors, Rx/Tx......... 159/12 (0,7%/0,1%)
Frames Count, Rx/Tx.......... 22357/9666
Error Control Frame Size..... V.42 LAPM (128)
Error Control Timeouts....... 28
Error Control Link NAKs...... 12
Compression Dictionary Size.. V.42bis (2048)
Characters Received.......... 2904010
Characters Sent.............. 157339
Average CPS, Rx/Tx........... 3000/162
Characters Lost, Rx/Tx....... 0/0
Estimated Noise Level, -dBm.. 65




Inpro IDC 2814/5614 BXL/VR Diagnostics, Version 1.0.1.29
23.07.04 0:06:37 - Manual Diagnostics Request
--------------------------------------------------------
Modem type: IDC-5614BXL/VR+ (Plus) Firmware revision: V2.24

Time Online.................. 00:07:23
Termination Reason........... LOCAL REQUEST
Tx Rate (Last/Init/Min/Max).. 21600/21600/16800/21600 bps
Rx Rate (Last/Init/Min/Max).. 26400/28800/26400/28800 bps
Modulation................... V.34bis
Protocol/Compression......... LAP-M/V.42bis
Line Quality................. 127
Tx/Power Drop/Rx Level....... 15/0/48
SNR Last/Min/Max............. 34/32/34
Highest Rx/Tx State.......... 85/87
EQM Sum...................... 0039
RBS Pattern.................. NA
Rate Drop.................... NA
Digital Loss................. None
Retrains Issued/Granted/Auto. 0/1/0
Renegs Issued/Granted........ 1/6
FForwards/FBacks/Denied...... 0/1/0
Forced FB/FB after FF/MaxREJ. 1/0/8

Symbol Rate.................. 3200
Carrier Frequency Hz, Rx/Tx.. 1829/1829
EQM Value (Last/Min/Max)..... 127/27/127
EQM Hits..................... 0
EQM Last 10 Readings......... 127 40 44 38 37 36 38 39 37 42
Last Retrain/Reneg Status.... Remote Rate Renegotiation
Last Retrain/Reneg Reason.... Remote Rate Renegotiation
Reason for V.34 Fallback..... Data Pump decision to Fallback in Phase 2
Last Retrain/Reneg Time...... 2 minutes ago
Handshake Time/Retries....... 20 seconds/0
Non-linear Encoding, Rx/Tx... ON/OFF
Precoding, Rx/Tx............. ON/OFF
Shaping, Rx/Tx............... ON/OFF
Trellis Encoding, Tx......... 16 state
Pre-Emphasis Index, Tx....... 2
Band Edges Lower/Upper, Hz... 150/3825
Round trip delay, ms......... 7,3
Last Rx/Tx State............. 67/87
Energy at 3750Hz/Average .... 8/69
Detection of 120 Hz Tones.... Yes
Detection of Dual PCM........ Yes
V.8 Negotiation Started...... Yes
V.8bis Success............... Yes
V.8bis CRe,CRd,CL,MS,ACK,NAK. Yes/No/Yes/No/Yes/No
Remote Manufacturer.......... Rockwell (Conexant)
Remote Licensee Code......... Rockwell (Conexant)
Remote Protocol Support...... K56flex V.90
Remote K56flex Version....... 02
Remote K56flex Capabilities.. Prototype mode is not supported
Remote Type.................. Server (Digital)
Remote supports Symbol Rates. 2743 2800 3429 3000(L) 3000(H)
Remote supports Symbol Rates. 3200(L) 3200(H) 3429(Tx)
Remote supports Power Drop... Yes
Remote is CME Modem.......... No
Remote supports V.34bis...... Yes
Remote Max SR Difference..... 0 Symbol Rate Steps
Remote Frequency Source...... Internal
Error Correction Status Byte. SYNC UA:R SAMBE:T XID:T XID:R
Frames REJected, Last/Total.. 1/59
Frames Errors, Rx/Tx......... 59/14 (0,6%/0,3%)
Frames Count, Rx/Tx.......... 10298/4461
Error Control Frame Size..... V.42 LAPM (128)
Error Control Timeouts....... 4
Error Control Link NAKs...... 14
Compression Dictionary Size.. V.42bis (2048)
Characters Received.......... 1475151
Characters Sent.............. 63134
Average CPS, Rx/Tx........... 3329/142
Characters Lost, Rx/Tx....... 0/0
Estimated Noise Level, -dBm.. 82

[Technical Support]

Попробуйте такую строку инициализации:

S91=15 S210.7=1 +MS=11,,,,,,16800
_________________
Inpro
Technical Support

[andreww]

[Technical Support]

Ну что же, вполне достойный результат для Вашей линии. Так и работайте.
_________________
Inpro
Technical Support