Помогите настроить IDC 5614BXL VR PnP

[Дмитрий Бел.]

Модем висит на аналоговой плохой линии. Часто при звонке с телефона в динамике слышны шуршания и шорохи, так, что плохо слышно собеседника. Перезваниваешь - все ОК! До того как начались проблемы с конектом - связь была отличной без ретрейнов, стояла прошивка 2.20 или 2.21 не помню. Помогите, пожалуйста, настроить. :cry:


Это статистика

Inpro IDC Modems Diagnostics, Version 1.0.1.31
18.08.03 11:36:59 - Manual Diagnostics Request
--------------------------------------------------------
Modem type: IDC-5614BXL/VR+ (Plus) Firmware revision: V2.23

Time Online.................. 00:14:03
Termination Reason........... RETRAIN FAILURE
Tx Rate (Last/Init/Min/Max).. 24000/24000/21600/31200 bps
Rx Rate (Last/Init/Min/Max).. 31200/30667/28800/32000 bps
Modulation................... V.34bis
Protocol/Compression......... LAP-M/V.42bis
Line Quality................. 127
Tx/Power Drop/Rx Level....... 15/0/NA
SNR Last/Min/Max............. 29/29/31
Highest Rx/Tx State.......... 21/21
EQM Sum...................... 0039
RBS Pattern.................. 00
Rate Drop.................... NA
Digital Loss................. None
Retrains Issued/Granted/Auto. 1/3/2
Renegs Issued/Granted........ 12/0
FForwards/FBacks/Denied...... 5/8/0
Forced FB/FB after FF/MaxREJ. 5/3/8
Last dialed number........... P1023440
Flex fail

Symbol Rate.................. 3429
Carrier Frequency Hz, Rx/Tx.. 1959/1959
EQM Value (Last/Min/Max)..... 127/17/127
EQM Hits..................... 0
EQM Last 10 Readings......... 127 127 127 127 126 126 30 31 36 31
Last Retrain/Reneg Status.... Local Rate Renegotiation
Last Retrain/Reneg Reason.... Local Fallback due to High EQM
Reason for V.34 Fallback..... Data Pump decision to Fallback
Last Retrain/Reneg Time...... 1 minutes ago
Handshake Time/Retries....... 22 seconds/0
Non-linear Encoding, Rx/Tx... ON/ON
Precoding, Rx/Tx............. ON/ON
Shaping, Rx/Tx............... ON/ON
Trellis Encoding, Tx......... 16 state
Pre-Emphasis Index, Tx....... 1
Band Edges Lower/Upper, Hz... 150/3825
Round trip delay, ms......... 6,7
Last Rx/Tx State............. 20/21
Energy at 3750Hz/Average .... 758/598
Auto Gain Amplitude, db...... 10
Last AGC Gain Value.......... 0
Minimum AGC Gain Value....... 69
Maximum AGC Gain Value....... 107
Detection of 120 Hz Tones.... Yes
Detection of Dual PCM........ No
V.8 Negotiation Started...... Yes
V.8bis Success............... No
V.8bis CRe,CRd,CL,MS,ACK,NAK. No/No/No/No/No/No
Remote supports Symbol Rates. 2743 2800 3429 3000(L) 3000(H)
Remote supports Symbol Rates. 3200(L) 3200(H) 3429(Tx)
Remote supports Power Drop... Yes
Remote is CME Modem.......... No
Remote supports V.34bis...... Yes
Remote Max SR Difference..... 0 Symbol Rate Steps
Remote Frequency Source...... Unknown
Workaround Used.............. V90 Phase 2 Escape
Workaround Used.............. V34 Codex WA/V34 Stuck Phase2
Error Correction Status Byte. SYNC UA:R SAMBE:T XID:T XID:R
Frames REJected, Last/Total.. 0/227
Frames Errors, Rx/Tx......... 227/14 (1,7%/0,3%)
Frames Count, Rx/Tx.......... 13273/5058
Error Control Frame Size..... V.42 LAPM (128)
Error Control Timeouts....... 104
Error Control Link NAKs...... 14
Compression Dictionary Size.. V.42bis (2048)
Characters Received.......... 1549004
Characters Sent.............. 88500
Average CPS, Rx/Tx........... 1837/104
Characters Lost, Rx/Tx....... 0/0
Estimated Noise Level, -dBm.. 81

[Technical Support]

Пропишите такую команду в строку инициализации в свойствах модема:

S91=15 S210.7=1 +MS=11,,,,,,24000
_________________
Inpro
Technical Support